Richmond, BC · Blundell Road shop · Serving Metro Vancouver

PAINT PROTECTION
FILM RICHMOND.

Clear, satin and matte PPF, planned around how you drive and installed panel by panel in our Richmond shop. Most shops sell the film. What you are really paying for is the install — so this page shows you how to check one, ours included, before you book.

Partial front · full front from $1,699
From $999 + tax
Clear gloss, satin and matte films
STEK · UPPF
Plus 5- or 10-year film warranty
2-year workmanship
Full-body PPF, by appointment
4–5 business days

PPF installed in Richmond, BC.

  • Since 2016
  • 10577 Blundell Road
  • By appointment · Mon–Fri
  • (778) 653-5222

01 / PPF in Richmond, in short

WHAT PPF DOES. AND
WHAT IT DOESN’T.

The short answer

Paint protection film (PPF) is a clear, satin or matte urethane film installed over your car’s paint. It takes the rock chips, road grit, bug and bird-dropping etching and light scratches so the paint underneath doesn’t. Light marks in the film’s top coat generally fade with warmth.

At Black Label in Richmond, PPF starts at $999 + tax for partial front, $1,699 + tax for full front and $4,300 + tax for full body. We install STEK and UPPF film by appointment at 10577 Blundell Road.

It helps with

  • Rock chips from highway and bridge traffic
  • Winter sand and gravel kicked up by tires
  • Bug splatter and bird droppings etching the clear coat
  • Light scratches from bags, keys and parking-lot brushes

It won’t

  • Stop dents or deep gouges
  • Hide chips already in the paint — it seals them in
  • Add gloss on its own — that’s a coating’s job
  • Last forever — plan to replace it within the film’s warranty term

02 / Why the installer matters more than the film

SAME FILM. VERY
DIFFERENT INSTALLS.

STEK, XPEL and UPPF are all good films. When owners regret PPF, it is rarely the roll — it is one of these three things, and you can spot each one before you pay.

Close-up of a black car door edge with film wrapped around the edge

01

Exposed edges

Film that stops short of a panel edge leaves a line that collects dirt, lifts and shows on darker paint within months.

How to check

Ask to see close-ups of finished door, hood and bumper edges — not just wide shots.

Dark grey car hood under shop lights showing a film seam

02

Seams in plain sight

A seam across the hood or down a door is often a sign of a generic pre-cut kit laid flat instead of film shaped to your car.

How to check

Ask where every seam on your car will sit, and why — before the film goes on.

A gloved hand applying paint protection film to a white car

03

Blade marks in the paint

Trimming film with a knife on the car can score the clear coat. It is the most common complaint in bad-install threads — and the costliest to fix.

How to check

Ask how film is cut and trimmed, and what happens if the paint is marked.

03 / Before you book anywhere

SEVEN QUESTIONS TO
ASK ANY PPF SHOP.

Take this list to every quote, ours included. A good installer answers each one plainly and can show you the work behind it.

Ask
A good answer sounds like
At Black Label
01 Will the edges be wrapped?
Edges are wrapped around the panel wherever the panel allows, with any exceptions named up front.
Edges are wrapped wherever the panel allows. Where they can’t be, we show you where before we start.
02 Where will the seams sit on my car?
Seams are placed in jambs, body lines or under trim, and the installer can point to each one on your car.
We mark seam locations on your car at drop-off, so nothing on the finished panel surprises you.
03 How is the film cut — and does a blade touch my paint?
Patterns are cut off the car (plotter or bulk on a table), and any on-car trimming is done without cutting into clear coat.
Tell us your paint matters most and we explain exactly how your panels are cut and trimmed.
04 What happens to my paint before the film goes on?
A wash, decontamination and an honest look at chips, repaints and previous repairs — because film seals in whatever is under it.
We inspect the paint and previous repairs before confirming the film. Film doesn’t repair damage underneath it.
05 Which film exactly, and who backs which warranty?
A named product line, plus two separate warranties: the film maker’s for the material and the shop’s for the install.
STEK or UPPF, named on your quote. 2-year Black Label workmanship warranty, plus a 5-year (UPPF Blue Shark) or 10-year (STEK, Hammerhead) film warranty.
06 Where is it installed, and how long do you keep my car?
Indoors, in a clean, lit bay — with a realistic number of days, not a same-day promise for a full car.
Indoors at our Blundell Road shop, by appointment. Full-body PPF takes about 4–5 business days.
07 What if an edge lifts after I pick it up?
A post-install check and a clear answer on what the shop fixes, for how long, at no charge.
Lifting, bubbling or edge issues from the install are covered by our 2-year workmanship warranty.

Red flags in a PPF quote

If you hear these, keep shopping.

  • A full-body price far below every other quote, with no film line named
  • Only wide, glossy photos — no close-ups of edges or seams
  • “10-year warranty” with no mention of who covers the install
  • Pressure to add full body or a coating before anyone has looked at your car
Send us your car — we’ll answer all seven for it

04 / What it costs

HOW MUCH DOES PPF
COST IN RICHMOND?

The short answer

At Black Label, PPF starts at $999 + tax for partial front, $1,699 + tax for full front, $2,199 + tax for the track package and $4,300–$4,999 + tax for full body, depending on the film.

Partial front
$999 + tax
Full front
$1,699 + tax
Track package
$2,199 + tax
Full body · UPPF Blue Shark, 5-yr film
$4,300 + tax
Full body · STEK or Hammerhead, 10-yr film
$4,999 + tax

Starting prices in CAD. Final scope is confirmed after we see the car.

Why two Richmond quotes can be thousands apart

  1. Vehicle size and shape

    A Model 3 bumper and a Cybertruck or 911 front end use very different amounts of film and time.

  2. The film line

    Entry films and premium lines (STEK DYNOshield, UPPF) differ in clarity, stain resistance and warranty length.

  3. Edges, seams and badges

    Wrapping edges and removing badges or trim takes hours a quick install skips. You see the difference up close.

  4. Paint prep

    Chips, swirls or a repainted panel may need correction first — film locks in whatever is underneath.

  5. What’s actually covered

    “Full front” can mean the whole hood and fenders, or only the leading 18 inches. Compare panel lists, not package names.

05 / Choosing coverage

MOST DAILY DRIVERS
DON’T NEED FULL BODY.

Rock chips land where the air hits first. Choose coverage by where you drive and how long you’ll keep the car — not by the biggest package on the menu.

Partial front

01

Leading edges

From $999 + tax

Front bumper, leading part of the hood and fenders, mirror caps, headlights.

Right if you

Mostly drive in town and want the chip zone covered for the lowest cost.

Start here

02

Full front

From $1,699 + tax

Full hood and front fenders, front bumper, mirror caps, headlights, door cups and edges.

Right if you

Commute on Hwy 99 or the bridges and don’t want a visible film line across the hood.

Track package

03

Front + lower sides

From $2,199 + tax

Everything in full front, plus the lower doors below the body line and the A-pillars.

Right if you

Drive gravel, winter sand or wide tires that throw debris along the sides.

Full body

04

Every painted panel

$4,300 / $4,999 + tax

All painted exterior panels, including roof, quarters, rockers, trunk and rear bumper.

Right if you

Will keep the car 5+ years, have soft or dark paint, or want a satin or matte look.

Is PPF worth it for you?

It comes down to three things. Resale usually isn’t one of them.

01

How long you’ll keep it

Film pays off over years of chips you never see. Selling in two? Partial front, or nothing, may be the honest answer.

02

Where you drive

Highway, bridges, construction zones and winter sand chip paint fast. City errands, much less.

03

How much chips bother you

Most owners buy PPF for peace of mind, not resale. If touch-up paint doesn’t bother you, save the money.

See every panel in each package

07 / Film, warranty and lifespan

TWO WARRANTIES. KNOW
WHICH COVERS WHAT.

A “10-year warranty” usually means the film, not the install. Before you book anywhere, ask who stands behind each — and for how long.

The install · Black Label

2-year workmanship

Covers how the film was put on: lifting edges, bubbles or panels that need re-laying because of the install. We fix it at our Richmond shop.

The film · Manufacturer

5 or 10 years

UPPF Blue Shark series
5-year film warranty
STEK or Hammerhead
10-year film warranty

Covers the material itself — typically yellowing, cracking or delamination — under each maker’s terms.

How long it lasts

Plan on the film’s warranty term.

About 5 years for UPPF Blue Shark and up to 10 for STEK, with regular hand washing. Garage-kept cars usually do better.

Yellowing and stains

Modern film resists yellowing.

Older films yellowed; current lines are far more stable. Bird droppings and tree sap still need cleaning off within days.

Removal

Film comes off with heat.

On factory paint it peels cleanly. Repainted panels are the exception — removable film is not a guarantee every respray will tolerate removal.

Finish

Clear gloss, satin or matte.

Clear keeps your paint’s look. Satin and matte (like STEK DynoMatte) change the sheen while protecting it.

08 / What happens after you ask

FROM QUOTE TO PICKUP.

No deposit to ask. A quote request starts a conversation — it doesn’t book a date.

  1. 01

    Send your car

    Year, make, model, the coverage you’re considering and any chips, repaints or old film.

    Online form or (778) 653-5222
  2. 02

    Get a written scope

    Panels, film line, finish, price + tax and timing — confirmed before anything is scheduled.

    By email, before any booking
  3. 03

    Paint check at drop-off

    We look at the paint together, mark seams and agree on anything that needs prep first.

    10577 Blundell Road
  4. 04

    Install in the booth

    Wash, decontamination, then panel-by-panel installation indoors.

    Full body: about 4-5 business days
  5. 05

    Walk-around and aftercare

    We go over edges and seams with you, then explain washing and when to come back if anything lifts.

    Covered by 2-year workmanship

09 / Good to know

PPF questions.

The short answers to what owners ask us after the quote.

Should I get PPF before or after I take delivery of a new car?

As soon as you can after delivery — ideally before the first highway drive. We check the delivery paint first, because new cars can arrive with marks that film would seal in.

Can PPF go on a car that already has chips or a repaint?

Yes, but film protects from here on; it doesn’t erase what’s there. Chips can be touched up first, and a repainted panel needs to be fully cured. Tell us about both when you ask for a quote.

How do I wash a car with PPF? Are automatic washes OK?

Hand wash with a pH-neutral soap, skip brush car washes, and keep pressure-washer tips away from film edges. We’ll tell you how long to wait before the first wash.

Can I put a ceramic coating on top of PPF?

Yes. A film-safe coating adds slickness and makes washing easier, but it’s optional — the film does the protecting.

Does PPF affect my factory paint warranty?

Film is a removable aftermarket product. Keep your Black Label invoice with your car’s records, and ask your dealer about their own policy before you book.

Do you install PPF on Teslas and other EVs?

Yes — Model 3, Model Y, Model S, Model X and Cybertruck are among our most common PPF jobs. See our Tesla PPF page for model-specific coverage.

Do you offer mobile PPF installation?

No. Every install happens indoors at our Richmond shop, where we control dust, light and temperature.

Request a quote / Vancouver

Tell us about your vehicle.

Share the vehicle, service, finish or coverage, and preferred timing. We will use these details to review the project scope.